Goto Section: 87.197 | 87.213 | Table of Contents

FCC 87.199
Revised as of October 1, 2018
Goto Year:2017 | 2019
  § 87.199   Special requirements for 406.0-406.1 MHz ELTs.

   (a) 406.0-406.1 MHz ELTs use G1D emission. Except for the spurious
   emission limits specified in § 87.139(h), 406.0-406.1 MHz ELTs must meet
   all the technical and performance standards contained in the Radio
   Technical Commission for Aeronautics document titled “Minimum
   Operational Performance Standards 406 MHz Emergency Locator
   Transmitters (ELT)” Document No. RTCA/DO-204 dated September 29, 1989.
   The Director of the Federal Register approves this incorporation by
   reference in accordance with 5 U.S.C 552(a) and 1 CFR part 51. Copies
   of this standard can be inspected at the Federal Communications
   Commission, 445 12th Street SW., Washington, DC (Reference Information
   Center) or at the National Archives and Records Administration (NARA).
   For information on the availability of this material at NARA, call
   202-741-6030, or go to:
   http://www.archives.gov/federal_register/code_of_federal_regulations/ib
   r_locations.html. Copies of the RTCA standards also may be obtained
   from the Radio Technical Commission for Aeronautics, Inc., 1150 18th
   Street NW., Suite 910, Washington, DC 20036.

   (b) The 406.0-406.1 MHz ELT must contain as an integral part a homing
   beacon operating only on 121.500 MHz that meets all the requirements
   described in the RTCA Recommended Standards document described in
   paragraph (a) of this section. The 121.500 MHz homing beacon must have
   a continuous duty cycle that may be interrupted during the transmission
   of the 406.0-406.1 MHz signal only.

   (c) As part of its Supplier's Declaration of Conformity a 406.0-406.1
   MHz ELT, the ELT must be certified by a test facility recognized by one
   of the COSPAS/SARSAT Partners that the equipment satisfies the design
   characteristics associated with the COSPAS/SARSAT document
   COSPAS/SARSAT 406 MHz Distress Beacon Type Approval Standard (C/S
   T.007). Additionally, an independent test facility must certify that
   the ELT complies with the electrical and environmental standards
   associated with the RTCA Recommended Standards.

   Note 1 to paragraph (c): The verification procedure has been replaced
   by Supplier's Declaration of Conformity. Equipment previously
   authorized under subpart J of part 2 of this chapter may remain in use.
   See § 2.950 of this chapter.

   (d) The procedures for Supplier's Declaration of Conformity are
   contained in subpart J of part 2 of this chapter.

   (e) An identification code, issued by the National Oceanic and
   Atmospheric Administration (NOAA), the United States Program Manager
   for the 406.0-406.1 MHz COSPAS/SARSAT satellite system, must be
   programmed in each ELT unit to establish a unique identification for
   each ELT station. With each marketable ELT unit the manufacturer or
   grantee must include a postage pre-paid registration card printed with
   the ELT identification code addressed to: NOAA/SARSAT Beacon
   Registration, NSOF, E/SPO53, 1315 East West Hwy, Silver Spring, MD
   20910-9684. The registration card must request the owner's name,
   address, telephone, type of aircraft, alternate emergency contact, and
   other information as required by NOAA. The registration card must also
   contain information regarding the availability to register the ELT at
   NOAA's online Web-based registration database at:
   http://www.beaconregistration.noaa.gov. Further, the following
   statement must be included: “WARNING—failure to register this ELT with
   NOAA before installation could result in a monetary forfeiture being
   issued to the owner.”

   (f) To enhance protection of life and property, it is mandatory that
   each 406.0-406.1 MHz ELT must be registered with NOAA before
   installation and that information be kept up-to-date. In addition to
   the identification plate or label requirements contained in § § 2.925 and
   2.926 of this chapter, each 406.0-406.1 MHz ELT must be provided on the
   outside with a clearly discernable permanent plate or label containing
   the following statement: “The owner of this 406.0-406.1 MHz ELT must
   register the NOAA identification code contained on this label with the
   National Oceanic and Atmospheric Administration (NOAA), whose address
   is: NOAA/SARSAT Beacon Registration, NSOF, E/SPO53, 1315 East West Hwy,
   Silver Spring, MD 20910-9684.” Aircraft owners shall advise NOAA in
   writing upon change of aircraft or ELT ownership, or any other change
   in registration information. Fleet operators must notify NOAA upon
   transfer of ELT to another aircraft outside of the owner's control, or
   any other change in registration information. NOAA will provide
   registrants with proof of registration and change of registration
   postcards.

   (g) For 406.0-406.1 MHz ELTs whose identification code can be changed
   after manufacture, the identification code shown on the plant or label
   must be easily replaceable using commonly available tools.

   [ 69 FR 32885 , June 14, 2004, as amended at  76 FR 17352 , Mar. 29, 2011;
    79 FR 77918 , Dec. 29, 2014;  82 FR 50838 , Nov. 2, 2017]

   return arrow Back to Top

Subpart G—Aeronautical Advisory Stations (Unicoms)

   return arrow Back to Top


Goto Section: 87.197 | 87.213

Goto Year: 2017 | 2019
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public