Goto Section: 73.508 | 73.510 | Table of Contents
FCC 73.509
Revised as of
Goto Year:1996 |
1998
Sec. 73.509 Prohibited overlap.
(a) An application for a new or modified NCE-FM station other than a
Class D (secondary) station will not be accepted if the proposed
operation
[[Page 151]]
would involve overlap of signal strength contours with any other station
licensed by the Commission and operating in the reserved band (Channels
200-220, inclusive) as set forth below:
------------------------------------------------------------------------
Contour of Contour of other
Frequency separation proposed station station
------------------------------------------------------------------------
Co-channel...................... 0.1mV/m (40 dBu).. 1 mV/m (60 dBu).
1 mV/m (60 dBu)... 0.1 mV/m (40 dBu).
200 kHz......................... 0.5 mV/m (54 dBu). 1 mV/m (60 dBu).
1 mV/m (60 dBu)... 0.5 mV/m (54 dBu).
400 kHz......................... 10 mV/m (80 dBu).. 1 mV/m (60 dBu).
1 mV/m (60 dBu)... 10 mV/m (80 dBu).
600 kHz......................... 100 mV/m (100 dBu) 1 mV/m (60 dBu).
1 mV/m (60 dBu)... 100 mV/m (100
dBu).
------------------------------------------------------------------------
(b) An application by a Class D (secondary) station, other than an
application to change class, will not be accepted if the proposed
operation would involve overlap of signal strength contours with any
other station as set forth below:
------------------------------------------------------------------------
Contour of Contour of any
Frequency separation proposed station other station
------------------------------------------------------------------------
Co-channel...................... 0.1 mV/m (40 dBu). 1 mV/m (60 dBu).
200 kHz......................... 0.5 mV/m (54 dBu). 1 mV/m (60 dBu).
400 kHz......................... 10 mV/m (80 dBu).. 1 mV/m (60 dBu).
600 kHz......................... 100 mV/m (100 dBu) 1 mV/m (60 dBu).
------------------------------------------------------------------------
(c) The following standards must be used to compute the distances to
the pertinent contours:
(1) The distance of the 60 dBu (1 mV/m) contours are to be computed
using Figure 1 of Sec. 73.333 [F(50,50) curves] of this part.
(2) The distance to the other contours are to be computed using
Figure 1a of Sec. 73.333 [F(50,10) curves]. In the event that the
distance to the contour is below 16 kilometers (approximately 10 miles),
and therefore not covered by Figure 1a, curves in Figure 1 must be used.
(3) The effective radiated power (ERP) that is the maximum ERP for
any elevation plane on any bearing will be used.
(d) An application for a change (other than a change in channel) in
the facilities of a NCE-FM broadcast station will be accepted even
though overlap of signal strength contours, as specified in paragraphs
(a) and (b) of this section, would occur with another station in an area
where such overlap does not already exists, if:
(1) The total area of overlap with that station would not be
increased;
(2) The area of overlap with any other station would not increase;
(3) The area of overlap does not move significantly closer to the
station receiving the overlap; and,
(4) No area of overlap would be created with any station with which
the overlap does not now exist.
(e) The provisions of this section concerning prohibited overlap
will not apply where the area of such overlap lies entirely over water.
[ 50 FR 27962 , July 9, 1985, as amended at 52 FR 43765 , Nov. 16, 1987]
Goto Section: 73.508 | 73.510
Goto Year: 1996 |
1998
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public