FCC Web Documents citing 15.217

as compiled by hallikainen.com/FccRules on 2012 07 01

• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-00-163A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-00-163A1.pdf
  • receivers associated with UWB transmitters would attempt to recover as much of the transmitted bandwidth as possible for information processing purposes. Accordingly, we propose to eliminate this prohibition for UWB transmitters, and seek further comment on this proposal. Other Matters Several proponents of UWB devices have questioned whether such devices can operate under the standards contained in 47 C.F.R. §§ 15.217-15.255. This would result in a transmitter that may have a fundamental emission bandwidth greater than one gigahertz operating under the standards developed for a narrowband signal, e.g., the 30 MHz available for radar systems operating at 5800 MHz under 47 C.F.R. § 15.245. These requests were submitted in an attempt to permit the manufacturers to avail themselves of the higher
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-136A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-136A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-136A1.txt
  • addition, the LF spectrum is used by unlicensed devices. These systems do not have any allocation status, but are authorized to operate under our Part 15 Rules on an unprotected, non-interference basis with respect to all other users. Section 15.209 permits operation of authorized systems with field strengths of up to 4.9 microvolts/meter in the 9-490 kHz band. Additionally, Section 15.217 permits use of the 160-190 kHz band for general unlicensed operations limited to one watt total input power to the final radio frequency stage (exclusive of filament or heater power) with the length of the transmission line, antenna and ground lead not to exceed 15 meters. Emissions outside of the 160-190 kHz band must be attenuated by at least 20
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-48A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-48A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-02-48A1.txt
  • of Wide Bandwidth Systems under the Existing Rules Proposal. In the Notice, we proposed specific regulations regarding the frequency of operation and emission levels that would apply to UWB devices. We expressed concern that UWB manufacturers would wish to operate their products under a combination of both the UWB regulations and the existing Part 15 regulations in 47 C.F.R. §§ 15.217-15.255. This would result in a transmitter that has an extremely wide bandwidth attempting also to operate under standards that were developed for narrowband operation. An example would be a UWB device that operates at 5800 MHz attempting to demonstrate compliance with 47 C.F.R. § 15.245 over the frequency range 5785-5815 MHz while demonstrating compliance with the UWB emission limits outside
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-105A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-105A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-105A1.txt
  • In addition, unlicensed devices use the LF spectrum. These systems do not have any allocation status, but are authorized to operate under our Part 15 rules on an unprotected, non-interference basis with respect to all other users. Section 15.209 permits operation of authorized unlicensed systems with field strengths of up to 4.9 microvolts/meter in the 9-490 kHz band. Additionally, Section 15.217 permits use of the 160-190 kHz band for general unlicensed operations limited to one watt total input power to the final radio frequency stage (exclusive of filament or heater power) with the length of the transmission line, antenna and ground lead not to exceed 15 meters. Emissions outside of the 160-190 kHz band must be attenuated by at least 20
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.txt
  • considered sufficient to comply with the provisions of this Section. The manufacturer may design the unit so that a broken antenna can be replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This requirement does not apply to carrier current devices or to devices operated under the provisions of Sections 15.211, 15.213, 15.217, 15.219, or 15.221. Further, this requirement does not apply to intentional radiators that must be professionally installed, such as perimeter protection systems and some field disturbance sensors, or to other intentional radiators which, in accordance with Section 15.31(d), must be measured at the installation site. However, the installer shall be responsible for ensuring that the proper antenna is employed so
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-248A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-248A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-248A1.txt
  • * * * (d) * * * * * * * * (4) Any equipment operated under the provisions § 15.253, § 15.255 or § 15.257. * * * * * Section 15.215 is revised by amending paragraphs (a) and (c) to read as follows: § 15.215 Additional provisions to the general radiated emission limitations. (a) The regulations in §§ 15.217 through 15.257 provide alternatives to the general radiated emission limits for intentional radiators operating in specified frequency bands. Unless otherwise stated, there are no restrictions as to the types of operation permitted under these sections. * * * * * (c) Intentional radiators operating under the alternative provisions to the general emission limits, as contained in §§ 15.217 through 15.257
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-285A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-285A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-285A1.txt
  • should be consulted for determining pulse desensitization factors, as necessary. * * * * * 3. Section 15.215 is amended by revising paragraph (c), to read as follows: Section 15.215 Additional provisions to the general radiated emission limitations. * * * * * (c) Intentional radiators operating under the alternative provisions to the general emission limits, as contained in §§ 15.217 through 15.257 and in Subpart E of this part, must be designed to ensure that the 20 dB bandwidth of the emission, or whatever bandwidth may otherwise be specified in the specific rule section under which the equipment operates, is contained within the frequency band designated in the rule section under which the equipment is operated. The requirement to contain
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-71A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-71A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-04-71A1.txt
  • communications and allows experimentation with various radio techniques and technologies to further the understanding of radio use and the development of new technologies. See 47 C.F.R. § 97.1 See generally 47 C.F.R. Parts 5 and 15. The non-Federal Government fixed service in this band is regulated under Part 23 of the Commission's Rules. See 47 C.F.R. §§ 15.113, 15.209 and 15.217; see also 47 C.F.R. §2.106 footnote US294. In addition, section 15.209 permits operation of authorized unlicensed systems with field strengths of up to 4.9 microvolts/meter in the 9-490 kHz band, while section 15.217 permits use of the 160-190 kHz band for general unlicensed operations limited to one watt total input power to the final radio frequency stage (exclusive of filament
• http://www.fcc.gov/Bureaus/Engineering_Technology/Notices/2000/fcc00163.doc
  • receivers associated with UWB transmitters would attempt to recover as much of the transmitted bandwidth as possible for information processing purposes. Accordingly, we propose to eliminate this prohibition for UWB transmitters, and seek further comment on this proposal. Other Matters Several proponents of UWB devices have questioned whether such devices can operate under the standards contained in 47 C.F.R. §§ 15.217-15.255. This would result in a transmitter that may have a fundamental emission bandwidth greater than one gigahertz operating under the standards developed for a narrowband signal, e.g., the 30 MHz available for radar systems operating at 5800 MHz under 47 C.F.R. § 15.245. These requests were submitted in an attempt to permit the manufacturers to avail themselves of the higher