Goto Section: 15.317 | 15.321 | Table of Contents

FCC 15.319
Revised as of October 2, 2015
Goto Year:2014 | 2016
  § 15.319   General technical requirements.

   (a) [Reserved]

   (b) All transmissions must use only digital modulation techniques. Both
   asynchronous and isochronous operations are permitted within the 1920-1930
   MHz band.

   (c) Peak transmit power shall not exceed 100 microwatts multiplied by the
   square root of the emission bandwidth in hertz. Peak transmit power must be
   measured over any interval of continuous transmission using instrumentation
   calibrated in terms of an rms-equivalent voltage. The measurement results
   shall be properly adjusted for any instrument limitations, such as detector
   response times, limited resolution bandwidth capability when compared to the
   emission  bandwidth,  sensitivity,  etc.,  so as to obtain a true peak
   measurement for the emission in question over the full bandwidth of the
   channel.

   (d)  Power spectral density shall not exceed 3 milliwatts in any 3 kHz
   bandwidth as measured with a spectrum analyzer having a resolution bandwidth
   of 3 kHz.

   (e) The peak transmit power shall be reduced by the amount in decibels that
   the maximum directional gain of the antenna exceeds 3 dBi.

   (f) The device shall automatically discontinue transmission in case of
   either  absence of information to transmit or operational failure. The
   provisions in this section are not intended to preclude transmission of
   control and signaling information or use of repetitive codes used by certain
   digital technologies to complete frame or burst intervals.

   (g) Notwithstanding other technical requirements specified in this subpart,
   attenuation of emissions below the general emission limits in § 15.209 is not
   required.

   (h) Where there is a transition between limits, the tighter limit shall
   apply at the transition point.

   (i) Unlicensed PCS devices are subject to the radiofrequency radiation
   exposure requirements specified in § § 1.1307(b), 2.1091 and 2.1093 of this
   chapter, as appropriate. All equipment shall be considered to operate in a
   “general population/uncontrolled” environment. Applications for equipment
   authorization  of  devices operating under this section must contain a
   statement confirming compliance with these requirements for both fundamental
   emissions and unwanted emissions. Technical information showing the basis
   for this statement must be submitted to the Commission upon request.

   [ 58 FR 59180 , Nov. 8, 1993, as amended at  59 FR 32852 , June 24, 1994;  59 FR 40835 , Aug. 10, 1994;  60 FR 13073 , Mar. 10, 1995;  61 FR 41018 , Aug. 7, 1996;
    69 FR 62621 , Oct. 27, 2004;  69 FR 77949 , Dec. 29, 2004;  77 FR 43013 , July
   23, 2012]

   return arrow Back to Top


Goto Section: 15.317 | 15.321

Goto Year: 2014 | 2016
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public