Goto Section: 74.703 | 74.706 | Table of Contents
FCC 74.705
Revised as of October 1, 2014
Goto Year:2013 |
2015
§ 74.705 TV broadcast analog station protection.
(a) The TV broadcast station protected contour will be its Grade B
contour signal level as defined in § 73.683 and calculated from the
authorized maximum radiated power (without depression angle
correction), the horizontal radiation pattern, height above average
terrain in the pertinent direction, and the appropriate chart from
§ 73.699.
(b)(1) An application to construct a new low power TV or TV translator
station or change the facilities of an existing station will not be
accepted if it specifies a site which is within the protected contour
of a co-channel or first adjacent channel TV broadast station.
(2) Due to the frequency spacing which exists between TV Channels 4 and
5, between Channels 6 and 7, and between Channels 13 and 14, adjacent
channel protection standards shall not be applicable to these pairs of
channels. (See § 73.603(a) of part 73 of this chapter.)
(3) A UHF low power TV or TV translator construction permit application
will not be accepted if it specifies a site within the UHF TV broadcast
station's protected contour and proposes operation on a channel either
14 or 15 channels above the channel in use by the TV broadcast station.
(4) A UHF low power TV or TV translator construction permit application
will not be accepted if it specifies a site less than 100 kilometers
from the transmitter site of a UHF TV broadcast analog station
operating on a channel which is the seventh channel above the requested
channel, unless it can demonstrate that the service area of the low
power TV or TV translator station as established in § 74.707(a) is not
located in an area where the TV broadcast analog station is regularly
viewed.
(5) An application for a new UHF low power TV or TV translator
construction permit, a change of channel, or a major change in
facilities pursuant to § 73.3572 of this chapter proposing a maximum
effective radiated power of more than 50 kilowatts will not be accepted
if it specifies a site less than 32 kilometers from the transmitter
site of a UHF TV broadcast analog station operating on a channel which
is the second, third, or fourth channel above or below the requested
channel.
(c) The low power TV, TV translator, or TV booster station field
strength is calculated from the proposed effective radiated power (ERP)
and the antenna height above average terrain (HAAT) in pertinent
directions.
(1) For co-channel protection, the field strength is calculated using
Figure 9a, 10a, or 10c of § 73.699 (F(50,10) charts) of Part 73 of this
chapter.
(2) For low power TV, TV translator, and TV boosters that do not
specify the same channel as the TV broadcast station to be protected,
the field strength is calculated using Figure 9, 10, or 10b of § 73.699
(F(50,50) charts) of Part 73 of this chapter.
(d) A low power TV, TV translator, or TV booster station application
will not be accepted if the ratio in dB of its field strength to that
of the TV broadcast station at the protected contour fails to meet the
following:
(1) -45 dB for co-channel operations without offset carrier frequency
operation or -28 dB for offset carrier frequency operation. An
application requesting offset carrier frequency operation must include
the following:
(i) A requested offset designation (zero, plus, or minus) identifying
the proposed direction of the 10 kHz offset from the standard carrier
frequencies of the requested channel. If the offset designation is not
different from that of the station being protected, the -45 dB ratio
must be used.
(ii) A description of the means by which the low power TV, TV
translator, or TV booster station will be maintained within the
tolerances specified in § 74.761 for offset operation.
(2) 6 dB when the protected TV broadcast station operates on a VHF
channel that is one channel above the requested channel.
(3) 12 dB when the protected TV broadcast station operates on a VHF
channel that is one channel below the requested channel.
(4) 15 dB when the protected TV broadcast station operates on a UHF
channel that is one channel above or below the requested channel.
(5) 23 dB when the protected TV broadcast station operates on a UHF
channel that is fourteen channels below the requested channel.
(6) 6 dB when the protected TV broadcast station operates a UHF channel
that is fifteen channels below the requested channel.
(e) As an alternative to the preceding paragraphs of 74.705, an
applicant for a low power TV, TV translator or TV booster may make full
use of terrain shielding and Longley-Rice terrain dependent propagation
prediction methods to demonstrate that the proposed facility would not
be likely to cause interference to TV broadcast stations. Guidance on
using the Longley-Rice methodology is provided in OET Bulletin No. 69
(but also see § 74.793(d)). Copies of OET Bulletin No. 69 may be
inspected during normal business hours at the: Federal Communications
Commission, CY-C203, 445 12th Street, SW., Reference Information
Center, Washington, DC 20554. This document is also available through
the Internet on the FCC Home Page at http://www.fcc.gov.
[ 47 FR 21497 , May 18, 1982, as amended at 48 FR 21487 , May 12, 1983; 52 FR 31403 , Aug. 20, 1987; 62 FR 26721 , May 14, 1997; 65 FR 58467 , Sept.
29, 2000; 69 FR 69332 , Nov. 29, 2004]
return arrow Back to Top
Goto Section: 74.703 | 74.706
Goto Year: 2013 |
2015
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public