Goto Section: 95.633 | 95.637 | Table of Contents
FCC 95.635
Revised as of October 1, 2013
Goto Year:2012 |
2014
§ 95.635 Unwanted radiation.
(a) In addition to the procedures in part 2, the following requirements
apply to each transmitter both with and without the connection of all
attachments acceptable for use with the transmitter, such as an
external speaker, microphone, power cord, antenna, etc.
(b) The power of each unwanted emission shall be less than TP as
specified in the applicable paragraphs listed in the following table:
Transmitter Emission type Applicable paragraphs (b)
GMRS A1D, A3E, F1D, G1D, F3E, G3E with filtering (1), (3), (7).
A1D, A3E, F1D, G1D, F3E, G3E without filtering (5), (6), (7).
H1D, J1D, R1D, H3E, J3E, R3E (2), (4), (7).
FRS F3E with filtering (1), (3), (7).
R/C:
27 MHz As specified in § 95.631(b) (1), (3), (7).
72-76 MHz As specified in § 95.631(b) (1), (3), (7), (10), (11), (12).
CB A1D, A3E (1), (3), (8), (9).
H1D, J1D, R1D, H3E, J3E, R3E (2), (4), (8), (9).
A1D, A3E type accepted before September 10, 1976 (1), (3), (7).
H1D, J1D, R1D, H3E, J3E, R3E type accepted before September 10,
1986 (2), (4), (7).
LPRS As specified in paragraph (c).
MedRadio As specified in paragraph (d).
DSRCS-OBU As specified in paragraph (f) of this section.
(1) At least 25 dB (decibels) on any frequency removed from the center
of the authorized bandwidth by more than 50% up to and including 100%
of the authorized bandwidth.
(2) At least 25 dB on any frequency removed from the center of the
authorized bandwidth by more than 50% up to and including 150% of the
authorized bandwidth.
(3) At least 35 dB on any frequency removed from the center of the
authorized bandwidth by more than 100% up to and including 250% of the
authorized bandwidth.
(4) At least 35 dB on any frequency removed from the center of the
authorized bandwidth by more than 150% up to and including 250% of the
authorized bandwidth.
(5) At least 83 log10 (fd /5) dB on any frequency removed from the
center of the authorized bandwidth by a displacement frequency (fd in
kHz), of more than 5 kHz up to and including 10 kHz.
(6) At least 116 log10 (fd /6.1) dB, or if less, 50 + 10 log10 (T) dB,
on any frequency removed from the center of the authorized bandwidth by
a displacement frequency (fd in kHz), of more than 10 kHz up to and
including 250% of the authorized bandwidth.
(7) At least 43 + 10 log10 (T) dB on any frequency removed from the
center of the authorized bandwidth by more than 250%.
(8) At least 53 + 10 log10 (T) dB on any frequency removed from the
center of the authorized bandwidth by more than 250%.
(9) At least 60 dB on any frequency twice or greater than twice the
fundamental frequency.
(10) At least 45 dB on any frequency removed from the center of the
authorized bandwidth by more than 100% up to and including 125% of the
authorized bandwidth.
(11) At least 55 dB on any frequency removed from the center of the
authorized bandwidth by more than 125% up to and including 250% of the
authorized bandwidth.
(12) At least 56 + 10 log10 (T) dB on any frequency removed from the
center of the authorized bandwidth by more than 250%.
(c) For transmitters designed to operate in the LPRS, emissions shall
be attenuated in accordance with the following:
(1) Emissions for LPRS transmitters operating on standard band channels
(25 kHz) shall be attenuated below the unmodulated carrier in
accordance with the following:
(i) Emissions 12.5 kHz to 22.5 kHz away from the channel center
frequency: at least 30 dB; and
(ii) Emissions more than 22.5 kHz away from the channel center
frequency: at least 43 + 10log(carrier power in watts) dB.
(2) Emissions for LPRS transmitters operating on extra band channels
(50 kHz) shall be attenuated below the unmodulated carrier in
accordance with the following:
(i) Emissions 25 kHz to 35 kHz from the channel center frequency: at
least 30 dB; and
(ii) Emissions more than 35 kHz away from the channel center frequency:
at least 43 + 10log(carrier power in watts) dB.
(3) Emissions for LPRS transmitters operating on narrowband channels (5
kHz) shall be attenuated below the power (P) of the highest emission,
measured in peak values, contained within the authorized bandwidth (4
kHz) in accordance with the following:
(i) On any frequency within the authorized bandwidth: Zero dB;
(ii) On any frequency removed from the center of the authorized
bandwidth by a displacement frequency (fd in kHz) of more than 2 kHz up
to and including 3.75 kHz: The lesser of 30 + 20(fd -2) dB, or 55 + 10
log(P), or 65 dB; and
(iii) On any frequency beyond 3.75 kHz removed from the center of the
authorized bandwidth: At least 55 + 10 log(P) dB.
(4) Emissions from AMTS transmitters using a single 250 kHz channel
shall be attenuated below the unmodulated carrier in accordance with
the following:
(i) Emissions from 125 kHz to 135 kHz away from the channel center
frequency; at least 30 dB; and
(ii) Emissions more than 135 kHz away from the channel center
frequency; at least 43 + 10log(carrier power in watts) dB.
(d) For transmitters designed to operate in the MedRadio service,
emissions shall be attenuated in accordance with the following:
(1) Emissions from a MedRadio transmitter shall be attenuated to a
level no greater than the field strength limits shown in the following
table when they:
(i) Are more than 250 kHz outside of the 402-405 MHz band (for devices
designed to operate in the 402-405 MHz band);
(ii) Are more than 100 kHz outside of either the 401-402 MHz or 405-406
MHz bands (for devices designed to operate in the 401-402 MHz or
405-406 MHz bands);
(iii) Are in the 406.000-406.100 MHz band (for devices designed to
operate in the 401-402 MHz or 405-406 MHz bands); or
(iv) Are more than 2.5 MHz outside of the 413-419 MHz, 426-432 MHz,
438-444 MHz, or 451-457 MHz bands (for devices designed to operate in
the 413-457 MHz band).
Frequency
(MHz) Field
strength
(uV/m) Measurement
distance
(m)
30-88 100 3
88-216 150 3
216-960 200 3
960 and above 500 3
Note--At band edges, the tighter limit applies.
(v) Are more than 2.5 MHz outside of the 2360-2400 MHz band (for
devices designed to operate in the 2360-2400 MHz band).
(2) The emission limits shown in the table of paragraph (d)(1) are
based on measurements employing a CISPR quasi-peak detector except that
above 1 GHz, the limit is based on measurements employing an average
detector. Measurements above 1 GHz shall be performed using a minimum
resolution bandwidth of 1 MHz. See also § 95.605.
(3) The emissions from a MedRadio transmitter must be measured to at
least the tenth harmonic of the highest fundamental frequency designed
to be emitted by the transmitter.
(4) For devices designed to operate in the 402-405 MHz band: Emissions
within the band more than 150 kHz away from the center frequency of the
spectrum the transmission is intended to occupy and emissions 250 kHz
or less below 402 MHz or above 405 MHz band will be attenuated below
the maximum permitted output power by at least 20 dB.
(5) For devices designed to operate in the 401-402 MHz or 405-406 MHz
bands: Emissions between 401-401.85 MHz or 405-406 MHz within the
MedRadio bands that are more than 50 kHz away from the center frequency
of the spectrum the transmission is intended to occupy (or more than 75
kHz away from the center frequency of MedRadio transmitters operating
between 401.85-402 MHz) and emissions 100 kHz or less below 401 MHz or
above 406 MHz shall be attenuated below the maximum permitted output
power by at least 20 dB.
(6) For devices designed to operate in the 413-419 MHz, 426-432 MHz,
438-444 MHz, and 451-457 MHz bands: In the first 2.5 megahertz beyond
any of the frequency bands authorized for MMN operation, the EIRP level
associated with any unwanted emission must be attenuated within a 1
megahertz bandwidth by at least 20 dB relative to the maximum EIRP
level within any 1 megahertz of the fundamental emission.
(7) For devices designed to operate in the 2360-2400 MHz band: In the
first 2.5 megahertz beyond any of the frequency bands authorized for
MBAN operation, the EIRP level associated with any unwanted emission
must be attenuated within a 1 megahertz bandwidth by at least 20 dB
relative to the maximum EIRP level within any 1 megahertz of the
fundamental emission.
(8) Compliance with the limits described in subparagraphs (4) through
(6) are based on the use of measurement instrumentation employing a
peak detector function with an instrument resolution bandwidth
approximately equal to 1.0 percent of the emission bandwidth of the
device under measurement.
(e) For transmitters designed to operate in the MURS, transmitters
shall comply with the following:
Frequency Mask with audio low pass filter Mask without audio low pass
filter
151.820 MHz, 151.880 MHz and 151.940 MHz (1) (1)
154.570 MHz and 154.600 MHz (2) (3)
(1) Emission Mask 1 --For transmitters designed to operate with a 12.5
kHz channel bandwidth, any emission must be attenuated below the power
(P) of the highest emission contained within the authorized bandwidth
as follows:
(i) On any frequency from the center of the authorized bandwidth fo to
5.625 kHz removed from fo: Zero dB.
(ii) On any frequency removed from the center of the authorized
bandwidth by a displacement frequency (fd in kHz) of more than 5.625
kHz but no more than 12.5 kHz: at least 7.27(fd -2.88 kHz) dB.
(iii) On any frequency removed from the center of the authorized
bandwidth by a displacement frequency (fd in kHz) of more than 12.5
kHz: at least 50 + 10 log (P) dB or 70 dB, whichever is the lesser
attenuation.
(2) Emission Mask 2 --For transmitters designed to operate with a 25
kHz channel bandwidth that are equipped with an audio low-pass filter,
the power of any emission must be below the unmodulated carrier power
(P) as follows:
(i) On any frequency removed from the assigned frequency by more than
50 percent, but not more than 100 percent of the authorized bandwidth:
at least 25 dB.
(ii) On any frequency removed from the assigned frequency by more than
100 percent, but not more than 250 percent of the authorized bandwidth:
at least 35 dB.
(iii) On any frequency removed from the assigned frequency by more than
250 percent of the authorized bandwidth: at least 43 + 10 log (P) dB.
(3) Emission Mask 3 --For transmitters designed to operate with a 25
kHz channel bandwidth that are not equipped with an audio low-pass
filter, the power of any emission must be attenuated below the
unmodulated carrier output power (P) as follows:
(i) On any frequency removed from the center of the authorized
bandwidth by a displacement frequency (fd in kHz) of more than 5 kHz,
but not more than 10 kHz: at least 83 log (fd /5) dB.
(ii) On any frequency removed from the center of the authorized
bandwidth by a displacement frequency (fd in kHz) of more than 10 kHz,
but not more than 250 percent of the authorized bandwidth: at least 29
log (fd 2 /11) dB or 50 dB, whichever is the lesser attenuation.
(iii) On any frequency removed from the center of the authorized
bandwidth by more than 250 percent of the authorized bandwidth: at
least 43 + 10 log (P) dB.
(f) DSRCS-OBUs are governed under subpart L of this part.
[ 53 FR 36789 , Sept. 22, 1988, as amended at 56 FR 15837 , Apr. 18, 1991.
Redesignated and amended at 61 FR 28769 , 28770, June 6, 1996, and
further redesignated and amended at 61 FR 46567 , 46568, Sept. 4, 1996;
63 FR 36610 , July 7, 1998; 64 FR 69931 , Dec. 15, 1999; 65 FR 60878 ,
Oct. 13, 2000; 67 FR 63289 , Oct. 11, 2002; 69 FR 46446 , Aug. 3, 2004;
74 FR 22707 , May 14, 2009; 77 FR 4269 , Jan. 27, 2012; 77 FR 55733 ,
Sept. 11, 2012]
return arrow Back to Top
Goto Section: 95.633 | 95.637
Goto Year: 2012 |
2014
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public